Volatile constituents of Murraya koenigii fresh leaves using headspace solid phase microextraction--gas chromatography-mass spectrometry.

The volatile components of Murraya koenigii fresh leaves, collected from Surat Thani province, Thailand were studied by using headspace (HS) solid-phase microextraction (SPME) coupled with gas chromatography-mass spectrometry (GC-MS). The four fibers employed to extract the volatiles were polydimethylsiloxane (PDMS), polydimethylsiloxane-divinylbenzene (PDMS-DVB), carboxane-polydimethylsiloxane (CAR-PDMS) and polydimethylsiloxane-divinylbenzene-carboxane (PDMS-DVB-CAR). The volatile constituents of M. koenigii fresh leaves were also extracted by hydrodistillation and analyzed by GC-MS. Fifty-one compounds were identified by these fibers. Five major compounds, γ-terpinene, ß-caryophyllene, ß-phellandrene, a-selinene and a-pinene, were detected in all fibers. The PDMS-DVB-CAR fiber was considered as the best for trapping key volatiles of M. koenigii fresh leaves.

Determination of cefadroxil by sequential injection with spectrophotometric detector.

A sequential injection analysis (SIA) spectrophotometric procedure for cefadroxil determination has been developed. The SIA instrumentation was modified to achieve the desired function and operations by using the software developed to interface the PC with the conventional SIA system. The method is based on the measurement of a red, water-soluble product formed by the reaction between cefadroxil and 4-aminoantipyrine in the presence of alkaline potassium hexacyanoferrate(III) at 510 nm. Optimum conditions for determining the drug were investigated. Beer's law was obeyed over the concentration ranges of 1 - 10 mg L(-1) and 10 - 50 mg L(-1) with a detection limit (3 sigma) of 0.17 mg L(-1) and a limit of quantification (10 sigma) of 0.56 mg L(-1). The relative standard deviations of 1.98% and 1.93% for 5 mg L(-1) and 30 mg L(-1) of the drug, respectively (n = 11) are obtained. The proposed method has been applied satisfactorily to the determination of cefadroxil in commercial pharmaceutical formulations with a sampling rate of 100 h(-1). Results obtained were in good agreement with those obtained by the official HPLC method at the 95% confidence level.

Flow injection chemiluminescence determination of cefadroxil using potassium permanganate and formaldehyde system.

A simple, rapid and precise flow injection chemiluminescence (FI-CL) method is proposed for the determination of cefadroxil and is suitable for application to other antibiotics containing phenolic hydroxyl groups. A possible mechanism for this selectivity is suggested. The method is based on the CL-emitting reaction between cefadroxil and potassium permanganate in sulfuric acid medium, enhanced by formaldehyde (HCHO). Under the optimum conditions, calibration graphs over the ranges of 0.05-0.8 and 1.0-10.0 microg ml(-1) were obtained. The proposed method was successfully applied to the determination of cefadroxil in pharmaceutical formulations with no evidence of interference from common excipients. The detection limit (3sigma) of this method is 25 ng ml(-1) (6.9 x 10(-8) mol l(-1)). The relative standard deviation was less than 2% for 0.4 and 4.0 microg ml(-1) cefadroxil (n = 20). The sample throughput was found to be 120 h(-1).